I have been playing tekkit for a couple of weeks now, and have just now ran into difficulties with a huge EU drain that seems to be from no where. I originally had a batbox being charged by a geothermal generator that ran all my equipment - charging bench MK3, Rotary macerator, Induction Furnace, compressor and recycler. For the most part it did it all no problem. I upgraded to a nuclear reactor and upgraded to a MFE in place of the batbox. I had the nuclear reactor feeding power into a MFSU with that feeding power to a MV transformer, which is feeding power to the MFE. Seems a bit complex, but I wanted it that way so I could just pipe HV all throughout the base and just put a transformer down on whatever needed a lower voltage. I hooked up a oil fabricator with MV and it ran perfectly fine for hours on the nuclear reactor + geothermal generator combo. I came back later, and both the MFE and MFSU were completely empty. The geothermal generator was sitting there doing nothing. I put more uranium cells in the reactor (a 90 eu/t reactor) and I sat and watched the charge on the MFE. It would quickly get up to about 300 then go back to 0. Over and over again. So I disconnected everything, and it charged right up. I reconnected everything, and boom, it drains at easily the maximum of the glass fibre cable at 512 EU/t. I disconnect everything again, and look at my machines. When I hook the power up, the rotary macerator and induction furnace come on, but the compressor and centrifuge extractor would not power up. I disconnect the oil fabricator, same thing. I disconnect the compressor and centrifuge extractor, same thing. Any ideas on what could be draining all the EU here?