Computercraft/ccSensors question.

[Frized]

Hi all. I have a question regarding ccSensors.

I have it working fine except that when I display the readout it is partially off of the console screen. I sent the info to a larger monitor where it was the same way. The information read out on the right side of the screen is cut in half. I was wondering if there is a way to change the size of the text within the /ccSensors/console program?

Is there a way to change the size of the text in general?

Or, is there an alternate way to display the information?

Thanks for any help.

[anotheruser]

Hello!

There's a config file for the ComputerCraft ("...\.techniclauncher\tekkit\config\mod_ComputerCraft.cfg"). In that file there are two entries/lines ("terminal_width=", "terminal_height="). You can set the size of the displays in characters.

This solution is applicable to single player only.

[Frized]

Great, thank you so much for this information.

[aMUSiC_gr]

You should note also that ccSensors are very buggy in SMP. The sensor names are not saved on the servers and reset every time you log into the game, and the proximity sensors do not work as intended (and especially in computerCraft they don't work at all). Those are known bugs and they will be addressed when there is a first official release of openccsensors, which is the open source fork of the now defunct ccSensors mod.