Siddic

Well I'm trying to do away with the transport pipes and waterproof pipes to reduce lag, so I've spent the last few days figuring out tesseracts, building them, etc. However i've run into a bit of a snag... Right now I'm experimenting with 2 liquid tesseracts, 1 magmatic engine, 1 pump, etc. trying to pull lava from the nether to the overworld into 1 single magmatic engine to charge up a red cell. SS: http://screencast.com/t/LAShO2x5 Heres what I have in the nether: http://screencast.com/t/s0585sACA basically a pump, powered by 4 redstone engines (yes there is a hole under it) pumping into the tesseract, in send only mode, on the freq of the tesseract connected to the magmatic engine, in receive only mode. redstone current part is disabled on the menu so it should be on all the time... not sure what i'm missing here. any input would be appreciated, thanks!

got it. it needs wooden conductive pipes starting out of the producer, golden wont work.

and got it.... sigh im an idiot sorry for wasting your time. i was treating the input/output on the transformers like i did the batboxes, not realizing its the other way around, 1 input, 5 out, where as the batbox has inputs and 1 out. sigh. ty for your time

hrm i think something is wrong with the mfsu, the hv transformer to MFE, and it wont charge the MFE

or not... sigh :(

transformer! had to use a hv transformer! finally!

normal 40k eu batbox

basically the same thing except this time we upgraded to an mfsu from a normal batbox, and a ic2 hv consumer, from a ic2 lv one

so the mfsu isnt compatible with the conversion blocks ?

sigh, can you please tell me whats wrong so i can fix this ? i've tried putting the ic2 consumer right at the output of the mfsu, no luck, cant figure out whats wrong here.

engines make it run, yes, thats ONE WAY of powering the quarry. you do know there are usually multiple ways of doing things in tekkit right ? i posted here to find out whats wrong with the set up i currently have, as it has WORKED BEFORE, the only thing different is the mfsu, and the ic2 hv consumer, so im not sure if im using the right stuff, hence my POST here, and not on the bug board. im not going to post something on the bug board because i screwed it up when setting it up. thats not a bug, thats a setup issue. you are aware of the difference are you not ?

no its not the problem, it worked fine before with just pipes

great, i'm trying to use pipes, not engines. thanks for your input though.

..... mine did..

i've had it powered with bc pipes before without issue, and it worked great.